Product Description
About WOCA Intensive Wood Cleaner:
- WOOD PREPERATION – Cleans and opens the pores of raw wood for subsequent finishing steps insuring deeper penetration and better adhesion of stains, oils and waterbased finishes.
- EASY TO USE – Dilute this product with tap water and mop the floor to remove contaminants and open the wood to allow oil to penetrate below the surface of the raw wood. The Floor Cleaner will remove grease, grime and dirt from the surface
- IDEAL FOR ALL SPECIES OF WOOD – This product aids in the removal of oils and excess tannins that naturally occur in wood to promote adhesion. Can be used on all domestic and exotic woods.
- PREVENTS FUTURE TANNIN STAINING – Reduces black staining on woods high in tannins after exposure to water. Limits the dark spots due to water reacting with tannins naturally occurring in the wood.
- NOT FOR DAILY CLEANING – This strong formulation cleans without strong VOC’s which lower your indoor air quality and are bad for the environment. It is for preparation of the wood before refinishing.
Coverage: Approximately 2,000-3,000 square foot per liter
Intensive Wood Cleaner is a product that has been specially developed for the wood preparation of all indoor wooden surfaces, such as furniture, floors, kitchen tables paneling, cutting boards, worktops and the like. Designed to be used on untreated, oiled or polyurethaned surfaces before refinishing. It is effective to remove particularly stubborn stains, dirt, grime and oil spots before a surface is treated. Odorless waterbased technology will not make your home smell like a chemical factory.
- For unfinished, oiled, waxed, polyurethane or soaped indoor wood surfaces
- Effectively prepares the surfaces for treatment
- Basic cleaning and grease removal
- High efficiency
How to use Intensive Wood Cleaner
Use WOCA Wood Stain Remover for particular stubborn stains. Always remember to test on a less visible spot to check the compatibility of the surface with the product.
- Mix the Cleaner thoroughly.
- For untreated and Lacquered surfaces: Mix Intensive Wood Cleaner 1:40 with warm water. For Soap-treated or oiled wood surfaces: Mix Intensive Wood Cleaner 1:20 with warm water.
- Damp mop the wood surface with a well-wrung mop. If the surface is very dirty, repeat.
- Let the surface dry for 2-8 hours before subsequent treatment.
This product is NOT to be used for regular, everyday cleaning. For best results, use two buckets: one with soap water and the second with clean water to rinse the dirty mop.
California Proposition 65 - www.p65warnings.ca.gov
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Some examples of these chemicals are:
- lead from lead-based paints,
- crystalline silica from bricks and cement and other masonry products, and
- arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles.
